短期集中で勉強すれば、Cisco CCNP 300-135受験対策で8-10時間で十分だと思います

全てのIT職員はCiscoの300-135試験問題集をよく知っています。これは一般的に認められている最高級の認証で、勉強者のキャリアにヘルプを与えられます。勉強者はその認証を持っているのですか。Ciscoの300-135試験問題集は非常に難しい試験ですが、KtestのCiscoの300-135試験問題集を手に入れたら大丈夫です。Troubleshooting and Maintaining Cisco IP Networks試験が難しいと感じるのは良い方法を選択しないからです。Ktestを選んだら、成功の手を握ることがきるようになります。買う前に、300-135無料サンプルでダウンロードできます。Ktestは資格試験の準備に全面的な問題集を提供して、勉強者を成功に就職できるように 手伝います。

Share some CCNP 300-135 exam questions and answers below.
Ticket 4 NATACL

TROUBLE TICKET STATEMENT:

The implementation group has been using thetest bed to do a ¡®proof-of-concept¡¯that required both client 1 and client 2 to access the Web Server at 209.65.200.241.After several changed to interface status, network addressing, routing schemes and layer 2 connectivity, at trouble ticket has been opened indicating that client 1 cannot ping the 209.65.200.241 (internet Server).

show run by yourself to obtain the following information:

Configuration on R1

ip nat inside source list nat_pool interface Serial0/0/0/1 overload !

ip access-list standard nat_pool

permit 10.1.0.0

! interface Serial0/0/0/1

ip address 209.65.200.224 255.255.255.252

ip nat outside

! interfaceSerial0/0/0/0.12

ip address 10.1.1.1 255.255.255.252

ip nat inside

ip ospf message-digest-key 1 md5 TSHOOT

ip ospd authentication message-digest

On Which device is the fault condition located?

A. R1

B. R2

C. R3

D. R4

E. DSW1

F. DSW2

G. ASW1

Answer: A

Ticket 5 R1ACL

TROUBLE TICKET STATEMENT:

The implementation group has been using thetest bed to do a ¡®proof-of-concept¡¯that required both client 1 and client 2 to access the Web Server at 209.65.200.241.After several changed to interface status, network addressing, routing schemes and layer 2 connectivity, at trouble ticket has been opened indicating that client 1 cannot ping the 209.65.200.241 (internet Server).

show run by yourself to obtain the following information:

Client 1 is not able to reach the WebServer at 209.65.200.241. Initial troubleshooting shows that R1 is also not able to reach the WebServer. R1 also does not have any active BGP neighbor.

Configuration on R1

! interface Serial0/0/0/1

description link to ISP

ip address 209.65.200.224 255.255.255.252

ip access-group edge_security in

ip nat outside

ip virtual-reassembly

ntp brasdcast client

net broadcast key 1

no cdp enable

!! ip access-list nat_traffic permit 10.1.0.0 0.0.255.255

ip access-list nat_traffic permit 10.2.0.0 0.0.255.255

! ip access-list edge_security deny ip 10.0.0.0 0.255.255.255 any

ip access-list edge_security deny ip 172.16.0.0 0.15.255.255 any

ip access-list edge_security deny ip 192.168.0.0 0.0.255.255 any

ip access-list edge_security deny ip 127.0.0.0 0.255.255.255 any

ip access-list edge_security permit ip host 209.65.200.241 any

On which device is the fault condition located?

A. R1

B. R2

C. R3

D. R4

E. DSW1

F. DSW2

G. ASW1

Answer: A

The Fault Condition is related to which technology?

A. BGP

B. NTP

C. IP NAT

D. IPv4 OSPF Routing

E. IPv4 OSPF Redistribution

F. IPv6 OSPF Routing

G. IPv4 layer 3 security

Answer: A

The fault condition is related to which technology?

A. NTP

B. IPv4 OSPF Routing

C. IPv6 OSPF Routing

D. IPV4 and IPV6 Interoperability

E. IPv4 layer 3 security

Answer: D

What is the solution to the fault condition?

A. Under the interface Tunnel34 configuration enter the ipv6 ospf 6 area 34 command.

B. Under the interface Loopback6 configuration enter the ipv6 ospf 6 area 34 command.

C. Under the interface Serial0/0/0.34 configuration enter the ipv6 ospf 6 area 34 command.

D. Under ipv6 router ospf 6 configuration enter the redistribute rip RIP_ZONE include-connected command.

Answer: D

How to check MTU of interface using ping? / How can you check the links mtu size with ping command?

A. ping 10.1.1.1 size 1501

B. ping 10.1.1.1 size 1500 df-bit

C. ping 10.1.1.1

D. ping 10.1.1.1 no-size

Answer: B

The Fault Condition is related to which technology?

A. BGP

B. NTP

C. IP NAT

D. IPv4 OSPF Routing

E. IPv4 OSPF Redistribution

F. IPv6 OSPF Routing

G. IPv4 layer 3 security

Answer: A

R1 and R2 OSPF neighbor.

Which two statements are true? (Choose two)

(Output from show ip ospf neighbors on 2 routers, one of them shows FULL/DR, the other FULL/-, you need to know how were they configured and will they exchange routes)

A. They are not neighbors

B. R1 (non-DR) will not update its routes to R2

C. Router R2 is configured with ospf point-to-point command (R2 is the router that shows as FULL/-)

D. They need to be configured as OSPF NBMA

E. R2 should be configured as stub

Answer: BC

受験者の最高のKtest試験トレーニング教材、および発見、CiscoCCNP認定資格質問と回答、気軽に試験に合格することができるんです。ご安心くださいね。

Ciscoはあなたに知識を与える認定します。あなたが開発し、スキルを学んだだろう。それはあなたのキャリアの次のレベルに行くことができます。あなたはあなたの専門知識の次のレベルにステップような方法で、より多くの機会は、あなたのキャリアの中で来ます。 CiscoがCCNP認定プロフェッショナルは、雇用者によって好まれます。CCNP認定資格はまた、より多くの企業がそれに多くの注意を払っているので、あなたの社会的地位を高めるためのショートカットです。あなたはキャリアパスに明るい未来を取得します。